Plastic Injection

We run series production on PLC controlled injection presses, using moulds we build ourselves.

Mould and press under one roof

In plastic injection, part quality is decided together by mould design, material behaviour and process parameters. Gökçeler Makina runs series production on PLC controlled injection presses using moulds it designs and builds itself. Because the mould and the press sit under the same roof, the step from trial shot to series production is short, and a dimensional deviation is solved by going back to the mould.

Process parameters

Parameters are set according to part geometry, material and mould design.

  • Wall thickness

    Directly sets fill speed, cooling time and shrinkage behaviour.

  • Material

    Engineering and commodity thermoplastics, selected by flow, shrinkage and thermal behaviour.

  • Cycle time

    When the cooling layout is designed well, time per part drops without losing quality.

  • Gate layout

    The gate position decides where the weld line, the warpage and the fill balance will appear.

Parts we produce

Series production parts moulded in our own tools.

Send us your part drawing; we will prepare mould feasibility, a material recommendation and a series production quotation.

Request a Quote